View Single Post
Old 08-14-2003, 11:08 AM
Thomaspin's Avatar
Thomaspin Thomaspin is offline
Join Date: Jun 2001
Location: CA
Posts: 531
Ideally, you should partly relieve the socket to clear the webbing on the block - a couple of the pins are very close to the web and your puller will be canted over if you do not do this, will not pull perpendicular to the pin and will bend. You can relieve an arc of the socket base on a mill. I would also turn the (usually) tapered top of the socket to be flat for maximum contact area.
Reply With Quote