View Single Post
Old 11-26-2000, 03:01 PM
Zoonhollis's Avatar
Zoonhollis Zoonhollis is offline
Diesel Fanatic
Join Date: Jun 2000
Location: Cary, NC
Posts: 551
I tried to adjust the valves on my 300D over the weekend, but it was only an exercise in futility. I had the two 14mm wrenches bent properly, but holding the large collar nut in place was virtually impossible. What does one use for this? A crescent wrench is out of the question, and channel-locks get just close enough to make me want to punch my head in utter frustration. I considered removing the fuel injectors, but declined for lack of time. Do I need to order a special wrench for this?

I found that most every exhaust valve was too tight, but the intakes were fine.

Grey/black '84 300D, 197K
Reply With Quote