Ignition Cylinder Lock Removal
I worked out a solution to getting the dreaded "stuck key in ignition" scenario and have read the many well-written threads on removing the cylinder lock. But something must not be clicking in my little brain. The 126 has 1 slot to insert a 1.3mm rod into at the #2 position. This is validated as it slides in deeper( 1/2") as you rotate the key at about 2'oclock and no where else through the starter activation is this possible. Should I feel something release? Other DIY's say the black retaining cap comes off easy counter clockwise - mine will not budge even with needle noose pliers assist. Where am I going astray?
Last edited by TX76513; 05-10-2005 at 03:34 PM.
Reason: subscribed to thread
|