View Single Post
Old 06-08-2001, 08:20 PM
benzfan's Avatar
benzfan benzfan is offline
Registered User
Join Date: May 2001
Location: Toronto
Posts: 277
I think that model is the same as the 2.3. It should have a small center nut with a pointer on one side and a larger outer nut. The inner should be turned until there is about 1mm of slack, then tightened (never more than a partial turn) until the pointer aligns with a notch or raised indicator on the outer nut. This should leave the proper amount of slack. You can leave another turn if you like to delay your kickdown. I never liked that effect though. I did find that it is relatively sensitive.
Reply With Quote