|
|
|
|
|
#1
10-30-2008, 06:00 PM
|
|||
|
|||
|
w124 B-pillar reinstall
I removed my B-pillars and had them recovered by a local upholstery shop. Removal is easy. Reinstallation is not going so well. Can anyone tell me how the pillar is supposed to interact with the two black plastic clips that are attached to the frame and go under the chafing strip? They are about 8 inches from the top if the pillar on either side. As best I can tell, there is nothing more than the top clip and the bottom plastic cover that hold this in place yet it is not snug for the top third and there is a gap between the cover and the edge of the chafing strip.
Many thanks, Rich
__________________
Rich Mason Chapel Hill, NC 1990 300D 285k miles 1993 VW Cabriolet converted to 1.6 TD 1985 VW Westfalia 1.6 TD 
|
|
#2
10-30-2008, 10:17 PM
|
|||
|
|||
|
You might do better with this question in the Bodywork section.
__________________
85 300D 75K Anthracite Grey 0-60 in 13 seconds **For Sale** 84 300D 333K Black (The Velveteen Rabbit) 0-60 in 14 seconds 00 Toyota Sienna 208K (Sold) 15 Subaru Outback 43K 11 Subaru Outback 67K 98 Ford Taurus 100K (Gertie - Was Grandma's - drove it to church and shopping - really) Daughter's car now. 30 Model A Ford 2 Door Sedan (Sold) 0-60 in . . . Never reached 60 
|
|
#3
10-30-2008, 10:29 PM
|
||||
|
||||
|
I believe that the door trim does much of the holding.
__________________
 Gone to the dark side - Jeff
|
 |
| Bookmarks |
|
|
Linear Mode
