|
|
|
|
|
#1
01-06-2005, 07:53 PM
|
||||
|
||||
Need quick help removing the B2 bushing!
If you've done your B2 piston this question is for you. Finally got my broken B2 piston out, but can't for the life of me get the bushing out. I have the new teflon one to replace it with. What kind of tool did you use? What kind of tool do I need to buy/make? Is it one piece with rubber part or what? Uggh! Help?
|
|
#2
01-06-2005, 08:32 PM
|
||||
|
||||
|
lol... can be a bit tricky! Sent you a PM.
__________________
|
|
#4
01-07-2005, 08:40 AM
|
|||
|
|||
|
I made a tool for this. Leathermang has it, as i sent it to him to start a "tool loaner" program. If you can get this tool I can explain what's needed so you are ready to go as soon as you get it. It's basically a specially modified washer and bolt that you put in, and the bushing can be pulled out very easily.
__________________
'82 300SD - 361K mi - "Blue" "Good judgement comes from experience. Experience comes from bad judgement." listen, look, .........and duck.
|
 |
| Bookmarks |
|
|
Linear Mode
