|
|
|
|
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
04-25-2005, 12:17 AM
|
||||
|
||||
|
Would it be safe to use a coolant heat exchanger when doing blends?
('87 300SDL) As I've stated in other posts I am wanting to run a blend of #2 and WVO. I was thinking/hoping to run 75% tops WVO unless I could run an even higher one. Anyways, I've read a lot about people adding in-line fuel heaters or heat exchangers in there engine bays, would the heating be okay even if there was diesel in the lines? The other threads I've read weren't really clear on it. I just wanted to make sure that I'm not going to turn my SDL into a rolling inferno
 Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 126 Windshield Defroster Heat Exchanger ? | Billybob | Diesel Discussion | 11 | 09-25-2007 07:38 PM |
| What is this heat exchanger for? | Rafi | Diesel Discussion | 16 | 03-29-2004 01:42 PM |
| Built-in diesel fuel heat exchanger??? | RunningTooHot | Diesel Discussion | 6 | 03-18-2004 10:30 AM |
| Interesting Post on AC from the Ritter/Easley Board | ctaylor738 | Tech Help | 4 | 08-08-2003 06:36 PM |
| injector heat shields for a 300D - are they necessary? | Kent300D | Diesel Discussion | 13 | 09-19-2002 11:18 PM |
Threaded Mode
