|
|
|
|
|
#1
06-05-2009, 07:52 PM
|
|||
|
|||
|
616 Transmission bolt size (for engine stand)
Hello!
I have a 616 I'd like to put on the stand this weekend but I haven't been able to find what size bolt I need to use. I assume they're the same as the tranny-to-engine bolts, but longer to account for spacing. Anyone know what size of bolt I need to use here? Thanks! 
|
|
#2
02-20-2011, 12:04 AM
|
||||
|
||||
|
OM616 bolts for engine stand
I can now state definitively that the threaded holes in the block and the upper oil pan of an OM616 engine are M10 x 1.5 mm coarse thread. If you're putting it on an engine stand you need to know that the blind holes in the upper portion of the block are approximately 25mm deep; add 25mm to the length needed to go through the engine stand bracket, subtract a few mm so that you can snug the bolt without bottoming out, and there's your bolt shank length!
Kurt
__________________
- '79 240D - engine swap complete! Engine broken in! 28-31 mpg! Lovin' the ride! - '86 190D (W201-126) - 2.5 NA engine, 5 speed, cloth interior, manual climate controls, 33-34 mpg (sold to forum member).
|
 |
| Bookmarks |
|
|
Linear Mode
