Vibration ,engine or ?
I changed the motor mounts and the front flex disc. I removed the trans mount and it looked good so i put it back. The rear flex disc is ok. I did valve a adjustment. So far as i could tell the drive shaft support looked good seemed to me to be solid, but I'm not that farmiliar with this. Tie rods were replaced. I increased the idle speed with the idle screw. still it vibrates like the mounts or trans mount were bad. Could it be something with the Injection pump. ANY HELP AT ALL IS APPRECIATED. RAY M
|
Car please.
|
As often as I've been here I should know better to start with the car 1980 300 d
Thanks for the heads up. Ray |
This is a car i got 2 months ago.Is it possible that he may have removed the axle and did not mark it to replace it in the correct alignment. Ray M
|
Is there a rack damper bolt on this model in1980? 300d
|
Quote:
|
Quote:
|
Have you cracked the fuel lines at each injector to see if there's any difference? May isolate an offending cylinder.
|
Sounds exactly like a rack damper bolt. I'm not sure if this car has it but I believe it does...
|
RD bolts on turbos only, and it smooths out above 1000 rpm.
|
Quote:
|
Could be a bad injector, could be low compression on one cylinder. Does you car have engine shocks. Those may help a little.
BTW, you seem to type with all caps a lots, can I ask why? |
IS THIS TYPING WITH ALL CAPS?
OR IS THIS TYPING WITH ALL CAPS? |
Quote:
|
Quote:
|
All times are GMT -4. The time now is 04:08 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website