|
|
|
|
|
#1
06-19-2016, 11:39 AM
|
|||
|
|||
|
HELP!!! Mono Wiper Assembly Removal 1991 300D 2.5
Following the instructions here: http://www.startekinfo.com/StarTek/outside/12264/disc_2/Program/Chassis/82-0680.pdf and also a manual from **************, I am attempting to remove the mono wiper assembly from the car so I can access the blower motor for routine maintenance.
I have all of the fasteners removed. But the assembly will not come out. I have wiggled it every which way. Almost like it won't clear the threaded shafts that the nuts screw onto. What do I do? 
|
|
#2
06-19-2016, 02:38 PM
|
||||
|
||||
|
Did you release the clamp #5 in the procedure?
__________________
The OM 642/722.9 powered family Still going strong 2014 ML350 Bluetec (wife's DD) 2013 E350 Bluetec (my DD) both my kids cars went to junkyard in 2023 2008 ML320 CDI (Older son’s DD) fatal transmission failure, water soaked/fried rear SAM, numerous other issues, just too far gone to save (165k miles) 2008 E320 Bluetec (Younger son's DD) injector failed open and diluted oil with diesel, spun main bearings (240k miles) 1998 E300DT sold to TimFreeh 1987 300TD sold to vstech
|
|
#3
06-19-2016, 10:19 PM
|
||||
|
||||
|
Hood fully up and latched, wiper raissd from windshield and latched, once all bolts are loose it should be able to be rotated up and down to release it from the mount bolts and lift out with the wiper still on it.
I have done this several times, just recently for a windshield replacement.
|
 |
| Bookmarks |
|
|
Linear Mode
