I started the removal process of my axles today to replace the cv boots. Started at the rear drivers side. After removing the center bolt of the axle, I slid it out as far as it could go hoping it would clear the hub but I could not get it to clear. I am being extra careful not to bang on it or force it.

Is there anything ai need to do different? I was hoping I could just replace the boots in place.

Took a picture just now but this is after I slid the axle back in place for the time being. I actually will take out the pressure washer later and pressure wash the differential area cuz I think I may just take out the whole axle anyway.

Attached Thumbnails

   

__________________
the sooner you start... the sooner you'll get done If it ain't broke, don't fix it.. Its always simpler to tell the truth...
2007 Honda Accord EX
2007 Honda Accord SE V6
96 C220
97 Explorer - Found Another Home
2000 Honda Accord V6 - Found Another Home
85 300D - Found Another Home
84 300D - Found Another Home
80 300TD - Found Another Home
Previous cars:
96 Caravan
87 Camry
84 Cressida
82 Vanagon
80 Fiesta
78 Nova
Ford Cortina
Opel Kadet
68 Kombi
Contessa