need some torque specs please...
 

cannot seem to locate the torque specs for the following....

-all nuts for manifolds
-turbo mount nuts-20-25
-exhaust hanger on tranny-20
-flange at exhaust-20
-water pump housing to block-27-33
-water pump-10
-thermostat housing to block
-thermostat cover-9-11
-engine support nut(not engine mount,its the arm sticking out from engine)
-large pulley holding harmonic balancer in place

Is there somewhere in the FSM that lists thes specs?

Do these look right so far?

270 - 330 Nm for the main crankshaft bolt

t-stat cover 9-11 Nm

pump to housing 10 Nm

housing to block 27-33 Nm

Tightening torques for turbo/ exhaust(Nm)
Self-locking hex. nuts on lateral support
of clamp 7
- -
Self-locking hex. nut on exhaust flange
to exhaust gas turbocharger 20-25
-
Self-locking hex. nut of exhaust pipe flange connection 20
Hex. screws of lateral support on transmission 20

thanks very much

not actually the main (center) nut, but rather the six that surround it and hold the pulley on.

I knew that Haynes manual was good for something.