cannot seem to locate the torque specs for the following....

-all nuts for manifolds
-turbo mount nuts-20-25
-exhaust hanger on tranny-20
-flange at exhaust-20
-water pump housing to block-27-33
-water pump-10
-thermostat housing to block
-thermostat cover-9-11
-engine support nut(not engine mount,its the arm sticking out from engine)
-large pulley holding harmonic balancer in place

Is there somewhere in the FSM that lists thes specs?

Do these look right so far?

__________________
1984 300D turbo 155k

www.interactivepainmanagement.com

270 - 330 Nm for the main crankshaft bolt

__________________

t-stat cover 9-11 Nm

__________________

pump to housing 10 Nm

__________________

housing to block 27-33 Nm

__________________

Tightening torques for turbo/ exhaust(Nm)
Self-locking hex. nuts on lateral support
of clamp 7
- -
Self-locking hex. nut on exhaust flange
to exhaust gas turbocharger 20-25
-
Self-locking hex. nut of exhaust pipe flange connection 20
Hex. screws of lateral support on transmission 20

__________________

thanks very much

__________________
1984 300D turbo 155k

www.interactivepainmanagement.com

not actually the main (center) nut, but rather the six that surround it and hold the pulley on.

__________________
1984 300D turbo 155k

www.interactivepainmanagement.com

I knew that Haynes manual was good for something.

__________________
1984 300SD Turbo Diesel 150,000 miles

OBK member #23

(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination