Transmissiuon torque specs
 

I looked at the online service manual with no luck, I found these specs once before in the manual. The following is what I found searching the forum..

W124 Flywheel to crank shaft 30-40Nm then 90 degree turn.
Pressure plate to flywheel 24 Nm
Bell housing to engine NOT FOUND


Can someone please tell me if these torque values sound correct and what the bell housing torque is, if any. I know those bolts are very tight.

Thanks

I believe that the trans to engine torque value is around 80-90ft lbs....not super tight, but quite tight. Do it in an alternating pattern.