|
|
|
#1
|
||||
|
||||
Transmissiuon torque specs
I looked at the online service manual with no luck, I found these specs once before in the manual. The following is what I found searching the forum..
W124 Flywheel to crank shaft 30-40Nm then 90 degree turn. Pressure plate to flywheel 24 Nm Bell housing to engine NOT FOUND Can someone please tell me if these torque values sound correct and what the bell housing torque is, if any. I know those bolts are very tight. Thanks
__________________
08 R320 CDI current Past 95 E420 87 300D Turbo 5spd 90 300TE 83 300SD 85 300TD 92 400E 85 190D |
#2
|
||||
|
||||
I believe that the trans to engine torque value is around 80-90ft lbs....not super tight, but quite tight. Do it in an alternating pattern.
__________________
-diesel is not just a fuel, its a way of life- '15 GLK250 Bluetec 118k - mine - (OC-123,800) '17 Metris(VITO!) - 37k - wifes (OC-41k) '09 Sprinter 3500 Winnebago View - 62k (OC - 67k) '13 ML350 Bluetec - 95k - dad's (OC-98k) '01 SL500 - 103k(km) - dad's (OC-110,000km) '16 E400 4matic Sedan - 148k - Brothers (OC-155k) |
Bookmarks |
|
|