|
|
|
|
|
#2
09-12-2011, 12:50 PM
|
|||
|
|||
|
Remove back seat.
Remove plastic access cover on driver's side. Not the shock absorber access cover, the other one. There it is. I ripped mine up for better access with a crescent wrench in the parts car. Upper left in the photo, you can see the black access cover sitting on the rear deck.
__________________
Greg 2012 S350 BlueTEC 4Matic 2007 ML 320 CDI 2007 Leisure Travel Serenity 2006 Sprinter 432k 2005 E320 CDI 1998 SLK230 (teal) 1998 SLK230 (silver) 1996 E300D 99k, 30k on WVO Previous: 1983 240D, on WVO 1982 300D, on WVO 1983 300CD, on WVO 1986 300SDL 237k, 25k on WVO (Deerslayer) 1991 350SDL 249k, 56k on WVO - Retired to a car spa in Phoenix 1983 380 SEC w/603 diesel, 8k on WVO 1996 E300D 351k, 177k on WVO 
|
|
#4
09-14-2011, 07:14 PM
|
||||
|
||||
|
If you don't have a reclining rear bench, push outwards the tabs where the seat cushion meets the carpet then lift the forward edge upwards then forwards then out. Remove 3 screws (8mm wrench) holding brackets extending down from the seat back to the rear bulkhead. Lift the seat back 3-4" then remove. You might have to first remove the headrests. Gently peel back the insulation over the rear bulkhead from the area described.
Sixto 87 300D
|
|
#5
09-14-2011, 07:16 PM
|
|||
|
|||
|
Little clips on the front bottom edge hold the lower seat. Then remove left, center, right 8-mm headed screws at bottom of seat back. Lift back up about an inch/25 mm, and remove. You will need a 46 mm to remove the sender, same size as for the strainer at the bottom of the tank.
Installation, as they say, is reverse. Need to type faster next time.
__________________
James Marriott 2003 Buick Regal 1983 300D (228k, frau Auto) 1996 Suburban K2500 (192k, 6.5 turbo diesel/4WD towmaster 10,000) www.engineeringworks.biz 1987 300SDL junker 170k 1982 300SD junker, 265k
|
 |
| Bookmarks |
|
|
Linear Mode
