Coolant flow on 1978 300D for heater and servo?

[biopete]

Anyone have a diagram? I'm getting page not found on my factory manual CD. Apparently it didn't come with coolant flow for this from heater core to servo etc. Didn't see it in the climate control manual. Did'nt see it searching.

I'm trying to figure out how to bypass coolant at leaking servo and understand the coolant flow. The posts on bypassing servo that i have found don't get too descriptive about what lines go where and what to hook up.

Here are some questions someone might help me out with.

1) in this pic: Which is the inlet and outlet to the heater core? I'm thinking the big one is the inlet. Which means that is where i need to hook up the outlet to the pump.

2) What are there two pipes coming out of firewall that join togeter for return from heater core? (assuming that is the return from heater core)

3) If im right about the return and the supply to heater core, that means i have hook up the four lines at the servo on diagonals -- that is in this fasion: The line from the aux water pump for heater goes to heater core inlet which is diagonally across from it on the servo. And the return comes into the servo diagonal from the return to water pump line .

Don't you need to T the return to water pump and supply line from heater pump together as well though for when you have the water flow to the heater core blocked off with the manual valve?

Any help is much appreciated .