|
|
|
#1
|
||||
|
||||
Mono valve is leaking
So another problem has crept up on the 300SD. I recently changed the mono valve since the old one had a torn diaphragm. But now it has started leaking coolant everywhere around it. I don't know if I missed a seal or something there or what.
Can someone shed some light on this?
__________________
'85 Mercedes 300SD W126 '99.5 Jetta TDI |
#2
|
||||
|
||||
.
it looks like you miss to properly put back some hose or clamp more than seal issue... you did not say did you replace just a monovalve or you did seal replacement... in short,did you see the "inner" parts..? .
__________________
w126 500SEC gen II euro, powered by OM617 turbo stolen from 84 300SD 2.88 diff,EGR blinded next wish/project: w114 coupe OM603 powered |
#3
|
|||
|
|||
Long-distance leak detection almost always occurs in the dark.
__________________
When cryptography is outlawed, bayl bhgynjf jvyy unir cevinpl. |
#4
|
||||
|
||||
Well I decided to take the thing apart again this morning to see if I could figure out what's going on. After I put everything back together and got it good and hot and the system pressurized, I took a look at it to see if I could find anything.
Turns out my brand new valve has a pin hole in it... So, looks like I'll be contacting Mercedes Source and asking for a new one.
__________________
'85 Mercedes 300SD W126 '99.5 Jetta TDI |
#5
|
||||
|
||||
,.
crazy .
__________________
w126 500SEC gen II euro, powered by OM617 turbo stolen from 84 300SD 2.88 diff,EGR blinded next wish/project: w114 coupe OM603 powered |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|