|
|
|
|
|
#1
09-19-2012, 11:23 PM
|
||||
|
||||
|
240 D no start
616 engine ran fine and started easily sitting in the bay and running on ATF/diesel in a bottle, also started fine when hooked up to fuel lines and primed, ran w/ euro manifolds (no air cleaner for euro manifolds tho).
Installed air federal (I think, ugly egr setup connecting the manifolds) manifolds, water pump, radiator, chain tensioner gasket, throttle linkages, driveshaft, exhaust yada yada yada. Hit the starter, starts right up (well, after I reconnected the ground) vague crunching noise and stops. Spins, primes OK, injectors bleed OK. No firing of any kind Ideas? I hope that vague crunching noise was because the engine stopped suddenly and not the other way around. Looked in the oil cap didn't see chips, haven't pulled the valve cover yet.
__________________
CC: NSA All things are burning, know this and be released. 82 Benz 240 D, Kuan Yin 12 Ford Escape 4wd You're four times It's hard to more likely to concentrate on have an accident two things when you're on at the same time. a cell phone. www.kiva.org It's not like there's anything wrong with feeling good, is there? 
|
| Bookmarks |
|
|
Threaded Mode
