|
|
|
|
|
#1
10-15-2012, 11:11 AM
|
|||
|
|||
|
HELP! Wagon rear glass seal problem
So, this seems to be happening.
  Not sure how it happened, or when honestly. Might have been that way since I bought it in February. But I want to fix this. Looks like the inner lip on the passenger side of the glass is pulling up from the top to bottom corner. Driver's side, top and bottom sides look fine. I tried using a wide plastic ice scraper to shove the inner lip back in but to no avail (might have made it worse). Is there any way to fix this without removing the glass?
__________________
1984 300TD Turbodiesel - 272k - Daily Duty 1985 300D Turbodiesel - 315k - "Recommended for competition events only" Last edited by Secondaries; 10-15-2012 at 08:11 PM. Reason: edited to be more visible :P 
|
|
#2
10-15-2012, 08:11 PM
|
|||
|
|||
|
Bump.. Any help or experience is greatly appreciated.
__________________
1984 300TD Turbodiesel - 272k - Daily Duty 1985 300D Turbodiesel - 315k - "Recommended for competition events only"
|
|
#3
10-15-2012, 10:11 PM
|
||||
|
||||
|
I don't have a Wagon when I removed my Rear Window I remoed the Alminum Trim and that released the Tension on the Window Rubber so it could be shifted around. (I reused My old Rubber as the Window had apprently been replaced with a Junk Yard one and the Seal seemed new.)
When the Aluminum Trim is inserted it pushes the Rubber side ways and locks the Window in place. Did the PO replace that Window or the Rubber Seal (I don't see any Sealant). If the Seal and/or Window was reaplace with an aftermarket one it simply may not fit. Is it possible that the Back Door is Bent or warped?
__________________
84 300D, 82 Volvo 244Gl Diesel
|
 |
| Bookmarks |
|
|
Linear Mode
