W126_Rubber Boot_drive shaft center support bearing

		PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Diesel Discussion
W126_Rubber Boot_drive shaft center support bearing

06-08-2010, 01:19 AM

whunter

Moderator

Join Date: Dec 2003

Location: Metro Detroit, Michigan

Posts: 17,430

View Photos By: whunter

W126_Rubber Boot_drive shaft center support bearing

MARK THE DRIVE SHAFT FOR RE-ASSEMBLY, BEFORE SEPARATING THE SLIP JOINT...

This rubber carrier boot can be replaced without disturbing the bearing.

I use a small pry bar against the boot edge, and tap it off/on with a small ball peen hammer.

NOTE:
Clean and lubricate the slip joint splines with axle grease before assembly..

Attached Thumbnails

Click image for larger version

Name: W126_Rubber Boot_drive shaft center support bearing_1.jpg
Views: 865
Size: 67.8 KB
ID: 81328

Click image for larger version

Name: W126_Rubber Boot_drive shaft center support bearing_2.jpg
Views: 1396
Size: 48.1 KB
ID: 81343

Click image for larger version

Name: W126_Rubber Boot_drive shaft center support bearing_3.jpg
Views: 2016
Size: 52.6 KB
ID: 81344

Last edited by whunter; 06-08-2010 at 04:55 PM.

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

All times are GMT -4. The time now is 01:46 PM.