|
|
|
|
|
#1
10-22-2017, 01:07 PM
|
||||
|
||||
|
Flyweel cover where to buy?
Hi,
I have an OM617 missing the oval plastic cover for the flywheel inspection hole. Does anyone know where this is located on the Pelican site? I nosed around and cannot locate it. 1982 300sd And do I need it? I was thinking dirt can get blown into my front seal on the tranny. Thanks. 
__________________
79 300TD “Old Smokey” AKA “The Mistake” (SOLD) 82 240D stick shift 335k miles (SOLD) 82 300SD 300k miles 85 300D Turbodiesel 170k miles 97 C280 147k miles 
|
|
#2
10-22-2017, 03:48 PM
|
||||
|
||||
|
Isn't the lower section of the bell housing open grating? I think the cover keeps the bolt heads clean. It's a long way from that port to the engine rear seal and transmission front seal. FWIW, the place in Bellingham sells it but the site doesn't provide a part number.
Sixto 98 E320s sedan and wagon
|
|
#3
10-22-2017, 08:08 PM
|
||||
|
||||
|
Ya know, you’re right. The bell housing is open where you drain the torque converter.
I siliconed a piece of plastic milk carton over the hole. Thanks for the tip on where to buy.
__________________
79 300TD “Old Smokey” AKA “The Mistake” (SOLD) 82 240D stick shift 335k miles (SOLD) 82 300SD 300k miles 85 300D Turbodiesel 170k miles 97 C280 147k miles
|
|
#5
10-23-2017, 07:59 PM
|
||||
|
||||
|
Thanks!
__________________
79 300TD “Old Smokey” AKA “The Mistake” (SOLD) 82 240D stick shift 335k miles (SOLD) 82 300SD 300k miles 85 300D Turbodiesel 170k miles 97 C280 147k miles
|
 |
| Bookmarks |
|
|
Linear Mode
