|
OM602 Oil Pan Torque Specs
Can't find the torque specs anywhere..
Just get them gütentite,eh? :-D Haha just kidding. |
Not too far off. I'd guess 8-10 ft.-lb.
You are trying to compress the gasket material, not crush it. This is about the only area where I would recommend a silicone sealant. |
Last time I did this, I not only used a light coat of sealant, I used a low strength locking compound on the bolts. Hopefully, it will still disassemble easily next time. But at least I'm leak-free.
|
Anyone have the specs from the manual?
I gotta get a new torque wrench anyways, so not in a huge hurry. And yea I was gonna use a little 3M gasket sealant on it! |
FSM says 10nm for 6mm bolts, 25nm for 8mm bolts.
|
Quote:
Much appreciated good sir :) |
| All times are GMT -4. The time now is 02:27 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website