Hi folks,

One of my side markers is causing some shorting out and blowing one of the fuses on my '74 240D.



Taking the lens out is of course a ten second job but inside the trunk has been stubborn so I want to ensure I don't break anything!



There's the two 7mm nuts to take out (done - ten seconds each again) but it's the rubber cover for the electrical connection that doesn't want to budge easily. It's reassuringly tight on there! Is there a trick to getting it out without damaging anything?

Thanks

__________________
1975 W115 300D

I don't think that comes off/unplugs from the back of the lamp. It should unplug from the harness approx 8" back.

Good luck!!!

__________________
"Rudeness is a weak man's imitation of strength" - Eric Hoffer

Can confirm they just pull out

Helps when you can escape the two weeks of non-stop rain to spend more than a few seconds on something!

__________________
1975 W115 300D

Good...yup working conditions can change everything...

__________________
"Rudeness is a weak man's imitation of strength" - Eric Hoffer