W140 S350 strange R603 block number. - PeachParts Mercedes-Benz Forum

Hardus1 · #1 12-04-2021, 07:57 AM

So I have a 1995 W140 S350 with the 3.5L OM603, I was trying to find the block number for cross references some parts for a rebuild. I've searched and read a few post and it showed that the block number was suppose to be near the injector pump but could not find it, however I eventually, "assuming", found the block number as it was located near the passenger side bottom of the block and it starts R then the usual number but it looks like this R 603 011 35 01 https://showbox.tools/ (see pic).

I didn't find the Original Mercedes-benz Tauschaggregat metal tags anywhere and the top of the pistons says 96/6 (see pic) so I'm assuming that it may be an original crank rods and blocks. I've look around at other OM603 blocks (both 3.0L and 3.5L) and I didn't find any that carries the letter R in front of the block number.

Anyone can give some insight of what it could mean or is just an irreverent anomaly that the 3.5 Om603 has? This car supposedly had an engine replaced 2 owners ago.

wallbenz · #2 12-05-2021, 02:20 PM

Quote:

Originally Posted by Hardus1

So I have a 1995 W140 S350 with the 3.5L OM603, I was trying to find the block number for cross references some parts for a rebuild. I've searched and read a few post and it showed that the block number was suppose to be near the injector pump but could not find it, however I eventually, "assuming", found the block number as it was located near the passenger side bottom of the block and it starts R then the usual number but it looks like this R 603 011 35 01 https://showbox.tools/ (see pic).

I didn't find the Original Mercedes-benz Tauschaggregat metal tags anywhere and the top of the pistons says 96/6 (see pic) so I'm assuming that it may be an original crank rods and blocks. I've look around at other OM603 blocks (both 3.0L and 3.5L) and I didn't find any that carries the letter R in front of the block number.

Anyone can give some insight of what it could mean or is just an irreverent anomaly that the 3.5 Om603 has? This car supposedly had an engine replaced 2 owners ago.

That R # is the Block number- same as what I have...
But you might be looking for the Serial # (engine)... that is supposed to be located near the Injection pump...

very difficult to see if engine is dirty. # is on etched on "finger" of block- facing sky just behind where the timing chain sits inside valve cover. and front side of Inj pump. if u want to PM me I can send you picts from my phone of where that S# hides.

I have a donor Motor 603 3.4l- w No number in that spot... so either its a
Rebuild... or someone intentionally ground # off to make it appear to be
upgrade" motor... I might have my mech open it up and boroscope- to figure that out.

Have you located new
Beefed" up connecting rods for your project? I might need to buy some in near future- if My motor needs them.

thx

compu_85 · #3 12-06-2021, 10:15 PM

If the motor has been rebuilt there will be a tag attached to the bellhousing with rivets. It's a little hard to see, but I doubt it would ever fall off.