![]() |
'83 300D "BRAKE" light stays lit, pads are fine...
The brake light stays on solid, but sometimes flickers a bit. I looked at both front brake pads and they are almost new and the sensors are plugged in like they should be. Any clue?... -- Mikey
|
The sensor or sensor leads could be shorting on something.
|
Unplug the sensors and see if the light goes out. You may have a defective sensor. If the light goeas out, then plug them back in one at a time to determine which sensor is bad.
|
check your brake fluid level
|
reply
Thanks Ned for the suggestion....I will try that. -- Mike
|
All times are GMT -4. The time now is 03:41 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website