|
|
|
|
|
#1
07-02-2003, 01:13 PM
|
||||
|
||||
THE light
I have an easy one for you. What is my 82 turbo diesel trying to tell me when the high beam light stays on?? Also, when I am on the road and i brake my car goes to the right, could it be just an allignment problem or should I start saving up for something else? Brake lines?? Thanks.
Last edited by Merz_82; 07-02-2003 at 01:21 PM. 
|
|
#2
07-03-2003, 04:34 AM
|
||||
|
||||
|
If car pulls to the right on braking, you might have frozen caliper on the left front that just aint grabbin. Something lots of people neglect is flushing the entire hydraulic system with fresh DOT4 fluid... starting with the brake line furthest from the master cylinder.
Havent heard of highbeams working overtime, but multi-switch on steering column is easy to disassemble for checking electrical contacts. What happens when you flash the highbeams by tapping the lever towards you?? Last edited by 300SDog; 07-03-2003 at 04:48 AM.
|
|
#3
07-03-2003, 10:06 AM
|
||||
|
||||
|
Like 240DieselDog said you could have a frozen caliper but you could also have a bad hose. they go bad on the inside so if you find the frozen caliper disconnect the hose and check to see if fluid is getting through before you remove the caliper.
__________________
 1985 Euro 240D 5 spd 140K 1979 240D 5 spd, 40K on engine rebuild 1994 Dodge/Cummins, 5 spd, 121K 1964 Allice Chalmers D15 tractor 2014 Kubota L3800 tractor 1964 VW bug "Lifes too short to drive a boring car"
|
|
#4
07-03-2003, 10:32 PM
|
||||
|
||||
|
My experience with pulling when braking usually points to the caliper on the same side it pulls to, i.e. it would be your right caliper and not your left if you're pulling to the right.
Do your headlights remain on high beam when the indicator remains lit? - if so it could be the switch itself.
__________________
1982 Mercedes-Benz 300CD 1982 Mercedes-Benz 240D - stick
|
|
#5
07-03-2003, 11:07 PM
|
|||
|
|||
|
Hi bjcsc:
240DieselDog is saying what you are saying, If it pulls on right, the right caliper might be locked or the left caliper might not be grabing. The end result will be the same i.e. pulling on right. Correct me if I am wrong. Just a clarification. MVK
__________________
One penny saved is three penny earned. 1985 300D Turbo 179,000miles
|
|
#6
07-05-2003, 08:16 PM
|
||||
|
||||
|
What's happening is that my high-beams do not come on at all but my dash indicates that they are already on- even if the high-beam lever is pulled towards me, So I can't get them to turn on and can't get my indicator to turn off. Thx for the replies
|
|
#7
07-05-2003, 09:19 PM
|
|||
|
|||
|
I'm not entirely certain, but I'm pretty sure that means your car is haunted.
|
 |
| Bookmarks |
|
|
Linear Mode
