Hi!

Im looking for EFI injectors that will fit in the original M104 3.0-24v intake.
For example the m104 2.8 or 3.2 injectors, how will they fit?

Is there at all something that will fit without modifying the intake ?
Maybe there is somewhere to get bungs that will make the injectors fit?



Regards,
Espen

Injector physical size is standardized across many car manufacturers. Look up Bosch EV1 or EV6 injectors. These are injector body styles which are interchangeable and available in many flow rates.

__________________
CENSORED due to not family friendly words

Thanks

I have tried injectors from BMW M50 but they didnt fit, as the cis injectors are a little bit wider.
On ebay i found siemens deka "long style" injectors, i will try to measure up the old cis injectors to see the difference on them.. might fit!

f.ex:
Home » Shop » Fuel » Injectors » Siemens DEKA IV ( DEKA 4 ) Mototron 80lb/hour High Impedance Injectors ( Long Style ) with EV1 Connector


Any thoughts ?

If i do understand well, you are trying to fit HFM Injector to a CIS injected engine?

If this is it, then it wont work at all. The setup is very different.

Why are you trying to do this swap?

Thanks

Ive found Siemens deka long style injectors, these seems to be wider than f.ex the injectors from bmw m50 i've tried. i will go meassure the old injectors to see how much off they are.

Im doing efi conversion on a 3.0 24v (cis-e) engine. Fuelrail from newer efi m104, megasquirt and so on
If anyone know where i can buy injector bungles for smaller injectors, that would also do the job.

I used Bosch EV6 injectors and M104 EFI fuel rail on my M103. All you have to do is trim some plastic off the injector body otherwise its drop in into the Kjet holes.
http://img.photobucket.com/albums/v242/tjts2/Green%20Mercedes/MS2/IMG_6627.jpg?t=1288305527

__________________
CENSORED due to not family friendly words

i used Injectors from 3.2 m104 with fuel rail from this model with stock fuel regulator. It pass as if it was designed for these model. You must cut off side mounts and make another two like on the middle