Parting Out-2-115's,2-116's, 3-123's, 2-124's and 3-126's - Page 68 - PeachParts Mercedes-Benz Forum

royrockz · #**1006** 10-04-2008, 09:36 AM

Jim.. I'm from Malaysia. May i know what are the interior and exterior parts for W123 you still have? Sorry i couldn't go through all 66 pages of the post.

Roy.

hdbill1@comcast · #**1007** 10-04-2008, 10:32 PM

i'm looking for right rear quarter panel 86 w126 (420 sel)
if so what color and price
bill
hdbill1@comcast.net

jim16671836 · #**1008** 10-04-2008, 10:58 PM

How much of the quarter panel do you need and where are you located??
I am in SW Indiana... Jim

Barike · #**1009** 10-05-2008, 11:21 AM

Hello Jim,

I'm hoping you still have a Dash Light Rheostat that could go into an '83 300SD, mine is shot, and I'd prefer to not have to pay the Fastlane prices. Would you also have the front drivers side window switch (dual switch) for the same car? Thanks, my email is ke5kwq@gmail.com

Daniel

David Hendy · #**1010** 10-07-2008, 08:36 AM

Need a black leather rear seat for a 124 sedan.

Also 4 rear subframe bolts & the big "washers"

thx

jasonleefreeman · #**1011** 10-21-2008, 07:03 PM

Would like to know if you have the following for 79 240d...

sunroof slide brackets that are bolted to the bottom of the panel.

The short portion of the sunroof guide tube that mounts on the bottom side of the panel, the one that the cable attaches to.

Off white (cream?) sunroof headliner.

Thanks,
Jason

jim16671836 · #**1012** 10-23-2008, 02:16 PM

From time to time I get some sun roof parts but none at this time... I have never tried to remove the head liner and I don't have any at this time... I will keep my eyes open... Jim

Gotha · #**1013** 10-24-2008, 05:43 PM

Hi Jim,

I have a 1975 W114 230.6. I believe your 1974 280 W115 has the same sheetmetal. I am looking for both front fenders, both passenger side doors, driver's rear door, rear euro bumper and front windshield. I am also looking for the valance under the front bumper. I have tried to find a parts car in my area of Virginia and have had no luck. let me know if you have these parts and pricing.

Many Thanks,
Gotha

jim16671836 · #**1014** 10-27-2008, 11:24 AM

Are you still looking for parts for your car??? Jim

gs sparhawk · #**1015** 10-27-2008, 02:15 PM

I still need a 230 driveshaft. ( And an idea how to get a simple carb to work on this. Maybe I should just get a 4-cyl injection unit to do the job.))

Sparky

jim16671836 · #**1016** 10-27-2008, 10:34 PM

I have located a 230... I think it is a 114 model... If it is the right model I will check about the drive shaft... If your 230 is fuel injected then you might need to stick with it.... Jim

gs sparhawk · #**1017** 10-27-2008, 11:31 PM

Wish I DID have FI. Maybe a system is around. don't particularly like the carb.
thanks for looking.

Sparky

jim16671836 · #**1018** 10-28-2008, 12:44 PM

While I am checking for the drive shaft I will also check and see if it has a carb. Jim

JB380SEL · #**1019** 10-31-2008, 02:55 AM

Hi Jim. I have a 1989 W126 420SEL. I need front and center mufflers. I have looked all over the internet and cannot find the front ones. Let me know. You can e-mail me---JBMERPAY@HOTMAIL.COM

Marrakesh Red · #**1020** 10-31-2008, 06:10 AM

Does anyone have the following:

Truck lid
rear bumper
Drivers door
Drivers rear quarter panel
Passengers rear quarter panel
Lower body cladding or molding on passenger door
Lower body cladding or molding on rear quarter panel
Rear Bumper and molding

Thank you all for any help or suggestions and please remember that this is for a Coupe and although some parts like the trunk are the same the doors are different.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The 126 does have a Monovalve	Lucy	Tech Help	3	03-16-2010 11:38 AM