Sawzall Party for W123 and 126
 

Rust free '78 W123 85 W126 parts cars about to get the knife.

Tell me what panel(s) you need and PM an offer.

rear passenger side wheel arch? The entire area including (and maybe 4-5" above) where that little trim piece is behind the door?

Mine is rusted/damaged, it'd be great to have a new piece to weld in.

Parts?
 

Engine for 83 300 SD?

126?

Maybe. I had plans to use it in another SD but it may just sit around for a few months.
Freight might make it cost prohibitive. Have you checked locally?

Yes. Would it be possible to cut out this section? I have someone that could do a repair to mine, I just need a good section of the car to put in.

If you'd like I could take a pic and mark the area I need cut out.

PM sent.

:eek::eek::eek::eek::eek:
Oh dear! Is this old Silver you are cutting up?? {'77 W123 if so}
Seems like the UCA's looked almost new in that thing, and I guess it might be smart for me to get that driver side rear trailing arm.......:o
Poor old car..........:(

Ever see a silver W123 convertable? :D

Hey, Whiskey, a time-lapse video of that would be very cool. Think about it . . .

http://www.tomcatauto.com/m67.jpg

:D

:smhair2:

My beloved first parts car. Oh the pain.......

:musicbooh

Use a blade called "The Torch" I find them at Lowe's. A little pricey but work great, and hard to break.

In the background, I have one that I prepared earlier

http://www.w108.org/gallery/albums/S...ts/500slc1.jpg

123 on block
 

could use rocker panel(s), and both rear fender lips, Still there?.