Mercedes 190D Massive Lot of New and Used Parts $300

[mysticguy]

Attention Mercedes 190D Fans Huge Parts Lot
For Sale is a huge lot of Mercedes 190 Parts. Parts will fit most 190’s from 1984 through 1993. Most parts were from my 1986 190D 2.5 liter diesel but will share commonalities with all 190’s gas or diesel. Many of the parts are new in boxes or used in fully functioning condition. Save big here as many of these parts are becoming harder and harder to find.

Highlights of parts are listed below but there are tons of smaller parts not listed here included. No Cherry Picking as I need to sell the whole lot to save time as well as to keep price low. Price is only $300 for this treasure trove of new and used 190 parts. Please PM for pickup. Sorry due to the size and weight of all the parts I cannot ship. Must pickup in Mystic, CT. Thank You

(3) Rims and Tires
New Bear Blower Motor
H4 Headlight Wires and Bulbs
New Ignition Switch
New Set of 6 Bosch Glow plugs for 5/6 Cylinder Diesel
Working Becker Radio with correct security Code
Complete new Timken Front Bearings set of 4 inner and outer
Bosal Center Muffler
OEM Jack
All AC Lines for 190
New Oil Filters for Diesel- Wix
New case of Fuel Filters for Diesel-Mann
New Serpentine Belt Continental for 2.5 Diesel
1 Wiper Assembly, Fresh Grease repack (complete)
2 Heater Valves
Rare Dual Pump Washer Fluid Reservoir
Vacuum locking control assembly(under rear seat)
New Power steering pump filter
Brake Booster
Master Cylinder
4 working Wheel Cylinders
New Corteco rear transmission seal
New Corteco Center support bushing
New Front wheel Seals-Victor Reinz
Engine Shroud
2 Complete working headlight wipers-RARE for 190 came from a Limited Edition
2 Lower Trim pieces for windshield wiper motors
Headlight Glass
Main engine rubber gasket seal at rear of engine
Complete wheel bolts set
OEM Stereo AMP for 1993
Hundreds of smaller parts, i.e., bolts, nuts , switches, relays, wires and many not listed here but some may seen in the pictures

[rally4s]

On 5cyl diesels, hard injection lines holders located between intake runners on intake manifold.