Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 2 1 2
Showing results 1 to 30 of 48
Search took 0.01 seconds. Search: Posts Made By: Oxen
Forum: Mercedes-Benz Performance Paddock 10-25-2022, 07:29 PM
Replies: 1
Views: 3,620
Posted By Oxen
w124/w201 trying to find a angle kit. maybe front sus swap?

i have a 1989 300d turbo small body car i believe its called a w124 or a 201 . they seem mechanically the same . im not very well schooled on these yet. so here i am . bugging you all .



but...
Forum: Diesel Discussion 03-20-2021, 02:21 PM
Replies: 11
Views: 656
Posted By Oxen
What's the stroke difference?

What's the stroke difference?
Forum: Diesel Discussion 03-20-2021, 02:04 PM
Replies: 11
Views: 656
Posted By Oxen
I'll look for 3.0 as well . Till I see what can...

I'll look for 3.0 as well . Till I see what can of worms I open up, possible to put 3.0 rods in this engine ?
Forum: Diesel Discussion 03-20-2021, 11:03 AM
Replies: 11
Views: 656
Posted By Oxen
How likely is a cracked blocked? I been surfing...

How likely is a cracked blocked? I been surfing eBay for engines.

I thought the heads in these can crack. So I am ready to buy a new head casing. ..... I didn't ponder a block would be a issue :(
Forum: Diesel Discussion 03-20-2021, 12:50 AM
Replies: 11
Views: 656
Posted By Oxen
yes 126 i will try to edit the post, i saw that...

yes 126 i will try to edit the post, i saw that .. i knew id get caught for it :p
Forum: Diesel Discussion 03-19-2021, 11:23 PM
Replies: 11
Views: 656
Posted By Oxen
hi, back after along slumber w126 questions

so i have acquired a 1991 350 sd super mint inside and out. w126


its mixing coolant and oil. an i was curious as to if the oil cooler could have just gone bad. car isn't over heating . that's...
Forum: Diesel Performance Tuning 08-31-2016, 12:23 PM
Replies: 2
Views: 2,795
Posted By Oxen
Okay put this project as side for a bit . Picked...

Okay put this project as side for a bit . Picked up a Pyro sensor for the profec controller. I hope to make some progress this week.
As well as build some silly 3 or 4 inch exhaust and intake for...
Forum: Diesel Performance Tuning 07-24-2016, 05:56 PM
Replies: 2
Views: 2,795
Posted By Oxen
adding boost 1987 300sdl.

So I bought a few parts to control the boost levels.

Be fore I get into those parts. I connected a gauge to the intake for a reference the boost is at 5 psi. From what I read that low even for...
Forum: Tech Help 07-21-2016, 12:00 AM
Replies: 5
Views: 673
Posted By Oxen
I hate auto correct. I'll fix my post later good...

I hate auto correct. I'll fix my post later good night.
Forum: Tech Help 07-20-2016, 11:54 PM
Replies: 5
Views: 673
Posted By Oxen
Okay I noticed the seat belt lights and stuff on...

Okay I noticed the seat belt lights and stuff on n the header panel with the sun roof button. I took out. Ripped up power seats, I put in black mechanical leather seats from a euro 380sec I belive...
Forum: Tech Help 07-20-2016, 06:35 PM
Replies: 5
Views: 673
Posted By Oxen
Yes very sorry. That's a spot on point mr. Is a...

Yes very sorry. That's a spot on point mr. Is a 1987 300SDL. It's like a land yatch :)
Forum: Tech Help 07-20-2016, 06:08 PM
Replies: 5
Views: 673
Posted By Oxen
odd issue recently popped up

I took out my power seats , and my door locks stopped working..... I hate to ask but is that possible? Nothing vaccine works now,and the car hangs if you Rev it up. .... also I had a window fall off...
Forum: Diesel Discussion 07-14-2016, 12:30 PM
Replies: 8
Views: 779
Posted By Oxen
So this 603 has a weird turbo mount . I guss...

So this 603 has a weird turbo mount . I guss where there used to be a oxedizer? Any one removed this odd ball leg and mounted a differ an if old or anything ? Pics would be super nice if anyone wants...
Forum: Diesel Discussion 07-14-2016, 12:26 PM
Replies: 8
Views: 779
Posted By Oxen
What's with the odd ball turbo mount on my 603?...

What's with the odd ball turbo mount on my 603? Any of you had a success at getting rid of that part?
Forum: Diesel Discussion 07-11-2016, 09:19 AM
Replies: 8
Views: 779
Posted By Oxen
Hey thanks gents . I will look on that Web site...

Hey thanks gents . I will look on that Web site and read as much as possible. Would you say 280,xxx miles is a lot? Should I plan to run this for a few years then swap for a 24v? I almost got a big...
Forum: Diesel Discussion 07-10-2016, 03:25 PM
Replies: 8
Views: 779
Posted By Oxen
I won't be running ac, possible to get a shorter...

I won't be running ac, possible to get a shorter belt and remove the compressor?

Also ,what are are the boost figures for the 603 ? I find a lot of 606 info , possibly I need a better key...
Forum: Diesel Discussion 07-10-2016, 04:29 AM
Replies: 8
Views: 779
Posted By Oxen
back at it few questons as usual

so I picked up a 87 sdl .thinking it had a 617 in it, to my surprise is a l6 .

would this unit be a om603?

I picked it up for a engine swap. possible to ditch the ecu ? as far as I can...
Forum: Diesel Discussion 02-05-2013, 04:00 PM
Replies: 29
Views: 2,444
Posted By Oxen
A center punch is a little tool for marking parts...

A center punch is a little tool for marking parts to be alighned or machine work. You push it down and it clicks. Depending on the setting soft or hard will determin the impact of the mark. On this i...
Forum: Diesel Discussion 02-05-2013, 10:24 AM
Replies: 29
Views: 2,444
Posted By Oxen
Ill center punch mark every thing for alignment. ...

Ill center punch mark every thing for alignment. It I will have the balance checked for sure.
Forum: Diesel Discussion 02-05-2013, 12:24 AM
Replies: 29
Views: 2,444
Posted By Oxen
OK and that I will know by taking both for...

OK and that I will know by taking both for balancing :)
Forum: Diesel Discussion 02-04-2013, 10:31 PM
Replies: 29
Views: 2,444
Posted By Oxen
Ok so i kinda feel like a dumb twat. The addapter...

Ok so i kinda feel like a dumb twat. The addapter kit comes with a crank addapter. To fit my jeep fly wheel to the 617 crank. I read that the jeep fly wheel is netral ballence. Now if its netral...
Forum: Diesel Discussion 02-04-2013, 02:30 PM
Replies: 29
Views: 2,444
Posted By Oxen
Damn come forth with the goods guys :) Im...

Damn come forth with the goods guys :)

Im trying to come up with the best options while i do this swap too my jeep. I do apreciate the input as im not Mercedes search literate yet. But im getting...
Forum: Diesel Discussion 02-04-2013, 02:46 AM
Replies: 29
Views: 2,444
Posted By Oxen
is a fly wheel a dealer only item?

is a fly wheel a dealer only item?
Forum: Diesel Discussion 02-04-2013, 12:49 AM
Replies: 5
Views: 1,261
Posted By Oxen
i'd rock that car .

i'd rock that car .
Forum: Diesel Discussion 02-03-2013, 11:46 PM
Replies: 29
Views: 2,444
Posted By Oxen
i found 300d fly wheel OUCH! trying to...

i found 300d fly wheel OUCH!

trying to source a 240 unit as well. i find the bolts ring gear and clutch kits but no FW yet .
Forum: Diesel Discussion 02-03-2013, 11:19 PM
Replies: 29
Views: 2,444
Posted By Oxen
i'll try looking for a 300 fw as well then. i...

i'll try looking for a 300 fw as well then. i thought those fw's were Europe only.
Forum: Diesel Discussion 02-03-2013, 10:51 PM
Replies: 29
Views: 2,444
Posted By Oxen
what i have found is a bunch of pish posh. about...

what i have found is a bunch of pish posh. about the fly wheel weight but not not about what year fly wheel to buy .

i will keep searching.
Forum: Diesel Discussion 02-03-2013, 09:21 PM
Replies: 29
Views: 2,444
Posted By Oxen
240-300d?

will a manul 240 d fly wheel fit a 300sd crank?
Forum: Diesel Discussion 01-28-2013, 02:00 PM
Replies: 5
Views: 747
Posted By Oxen
Thanks for the info guys. Ill read li ks on my...

Thanks for the info guys. Ill read li ks on my lunch here in a hour.
Forum: Diesel Discussion 01-27-2013, 08:34 PM
Replies: 5
Views: 747
Posted By Oxen
Ok so heres what im up to. I have a 617 from a 79...

Ok so heres what im up to. I have a 617 from a 79 300sd non egr . Its going into my 89 jeep Cherokee with a addapter plate to the jeep trans.
Showing results 1 to 30 of 48
Page 1 of 2 1 2

 
Forum Jump


All times are GMT -4. The time now is 01:35 PM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page