Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Search Today's Posts Mark Forums Read

Page 1 of 17 1 2311 Last »
Showing results 1 to 30 of 500
Search took 0.06 seconds. Search: Posts Made By: 79300sdtd
Forum: Diesel Discussion 05-27-2008, 08:25 AM
Replies: 6
Views: 742
Posted By 79300sdtd
ehh sometimes i think air bubbles can get into...

ehh sometimes i think air bubbles can get into the system... but CDI injection systems don't get hot enough to ignite the fuel.
Forum: Diesel Discussion 05-26-2008, 10:08 PM
Replies: 29
Views: 2,534
Posted By 79300sdtd
my blackberry does :P

my blackberry does :P
Forum: Diesel Discussion 05-22-2008, 06:36 PM
Replies: 12
Views: 973
Posted By 79300sdtd
you need like a 8 and 10 mm hex for starter and...

you need like a 8 and 10 mm hex for starter and engine mounts respectively, 13 mm for TC bolts, 17 mm for bellhousing bolts

when i go to a PNP i take a full tool box of common tools (set of metric...
Forum: Diesel Discussion 05-19-2008, 11:26 PM
Replies: 14
Views: 1,489
Posted By 79300sdtd
diesel911, i could not remember how many...

diesel911,

i could not remember how many there were but i think there are two just like yours in your post.
Forum: Diesel Discussion 05-19-2008, 10:19 PM
Replies: 14
Views: 1,489
Posted By 79300sdtd
did you replace the rubber washers on the shaft...

did you replace the rubber washers on the shaft (i think there is one) and the crush washer between the big bolt and the filter housing?
Forum: Diesel Discussion 05-17-2008, 07:23 PM
Replies: 6
Views: 1,086
Posted By 79300sdtd
very blind guess here... but... the front sump is...

very blind guess here... but... the front sump is in the way i think... you would need the ECU for the elecrtonics and possibly the TCU if you are going to use the auto tran that goes to that...
Forum: Diesel Discussion 05-16-2008, 08:29 PM
Replies: 69
Views: 6,085
Posted By 79300sdtd
nice car. i have a 617 parts doner engine if you...

nice car. i have a 617 parts doner engine if you need some parts. pm if interested.
Forum: Diesel Discussion 05-12-2008, 04:58 PM
Replies: 5
Views: 588
Posted By 79300sdtd
when i did it on my 300SD ( a 116 though) i laid...

when i did it on my 300SD ( a 116 though) i laid on the ground and reached up around the bell housing and hung on it till it broke free... then i went up top and finished it... this was all done with...
Forum: Diesel Discussion 05-12-2008, 03:12 PM
Replies: 4
Views: 644
Posted By 79300sdtd
geoff, you need to replace that "fuel"...

geoff,

you need to replace that "fuel" line... it does not carry fuel it vents excess pressure that the turbo could build up so that you do not get into an over boost situation.

it goes to the...
Forum: Diesel Discussion 05-11-2008, 10:47 PM
Replies: 22
Views: 1,963
Posted By 79300sdtd
if i saw this earlier.. i have an oil pan that...

if i saw this earlier.. i have an oil pan that has no use i believe it is in near perfect condition....it could have been yours for shipping and a few bucks
Forum: Diesel Discussion 05-09-2008, 02:41 PM
Replies: 16
Views: 2,144
Posted By 79300sdtd
if it is wrapped tight enough then it should not...

if it is wrapped tight enough then it should not cause any damage to the paint and will penetrate the skin easier :devil3:
Forum: Diesel Discussion 05-09-2008, 02:07 PM
Replies: 16
Views: 2,144
Posted By 79300sdtd
that is good but i was expecting to see a...

that is good but i was expecting to see a mechanism like bently's have, or a real badge wrapped in razor wire.
Forum: Diesel Discussion 05-09-2008, 11:16 AM
Replies: 4
Views: 640
Posted By 79300sdtd
"tighten" the crank shaft pulley bolt....

"tighten" the crank shaft pulley bolt. :cool:
Forum: Diesel Discussion 05-07-2008, 10:56 PM
Replies: 14
Views: 2,238
Posted By 79300sdtd
there's your problem... you have a gas pedal and...

there's your problem... you have a gas pedal and not an accelerator pedal. go to a junk yard and get the correct pedal :D
Forum: Diesel Discussion 05-07-2008, 08:28 AM
Replies: 10
Views: 955
Posted By 79300sdtd
i would have thought someone that has been...

i would have thought someone that has been registered since 2005 would have seen this question come up a few times and already know the answer:confused::confused::confused::confused::confused:
Forum: Diesel Discussion 05-01-2008, 03:17 PM
Replies: 22
Views: 1,846
Posted By 79300sdtd
if you are going by the rated 1.3L engine that is...

if you are going by the rated 1.3L engine that is where you are getting the horrible mileage figure from... yes a 1.3L engine should get better than 26mpg... but 26mpg is pretty good for a 3.9L
Forum: Diesel Discussion 05-01-2008, 02:08 PM
Replies: 22
Views: 1,846
Posted By 79300sdtd
the WANKEL is named after the MAN who created...

the WANKEL is named after the MAN who created it... dunno who owns the rights now but ford owns mazda.

as far as not being efficent through a variety of RPM that is bunk... the RX pulled very...
Forum: Diesel Discussion 05-01-2008, 08:35 AM
Replies: 22
Views: 1,846
Posted By 79300sdtd
close... i have had and seen RX-7's go 250k just...

close... i have had and seen RX-7's go 250k just fine... they are delicate engines but reliable... you have to run em so that carbon does not build up on the apex seals, and then you use compression....
Forum: Diesel Discussion 04-29-2008, 06:09 PM
Replies: 3
Views: 594
Posted By 79300sdtd
if you wanted to add a redundant LP you could buy...

if you wanted to add a redundant LP you could buy a kennedy LP and ad it too... still any tank.. it is a free flowing inline.
Forum: Diesel Discussion 04-24-2008, 11:06 PM
Replies: 52
Views: 7,382
Posted By 79300sdtd
Is that the turbo listed in your sig/ is it a...

Is that the turbo listed in your sig/ is it a liberty turbo? if it is a liberty turbo what year is it from?
Forum: Alternative Fuels 04-23-2008, 08:31 AM
Replies: 355
Views: 29,529
Posted By 79300sdtd
nah i don't think he is a criminal... there is no...

nah i don't think he is a criminal... there is no reason we should pay taxes on vehicles (or trailers) every time they are bought or sold.... the same for houses... the Gov't are the gimme-gimme's...
Forum: Diesel Discussion 04-21-2008, 07:46 AM
Replies: 10
Views: 953
Posted By 79300sdtd
don't you use power service?

don't you use power service?
Forum: Diesel Discussion 04-19-2008, 10:48 PM
Replies: 16
Views: 1,463
Posted By 79300sdtd
your S and W switch is for summer and winter if...

your S and W switch is for summer and winter if you didn't know
Forum: Diesel Discussion 04-19-2008, 09:47 PM
Replies: 16
Views: 1,463
Posted By 79300sdtd
my 80 SD had the "settings"

my 80 SD had the "settings"
Forum: Diesel Discussion 04-19-2008, 08:30 PM
Replies: 16
Views: 1,463
Posted By 79300sdtd
slope... if it is in this gear when you go down a...

slope... if it is in this gear when you go down a hill it will use the engine as a brake... it works really well. i think it will shift through 1, 2, and 3


low... 1st and 2nd gears only and a...
Forum: Diesel Discussion 04-17-2008, 09:00 PM
Replies: 55
Views: 3,141
Posted By 79300sdtd
one of my clients owns a station... he pays,...

one of my clients owns a station... he pays, after taxes, 4.23 a gal (3.60 something before taxes)... it is coming from above the local stations
Forum: Diesel Discussion 04-17-2008, 07:32 PM
Replies: 14
Views: 881
Posted By 79300sdtd
i disagree with busted. if your engine temp will...

i disagree with busted. if your engine temp will still register on the temp gauge at at least 60*c i don't think you need to glow
Forum: Diesel Discussion 04-16-2008, 02:16 PM
Replies: 2
Views: 629
Posted By 79300sdtd
check the flex disks for the clunk.... the...

check the flex disks for the clunk....

the reverse might be a band, others will chime in
Forum: Diesel Discussion 04-15-2008, 03:51 PM
Replies: 8
Views: 1,326
Posted By 79300sdtd
okay so you need to check out the blower first.....

okay so you need to check out the blower first.. the plug for it is way to get to... passenger side of the car take the kick panel of it should be on the outside of the car right there

one thing...
Forum: Diesel Discussion 04-15-2008, 03:28 PM
Replies: 8
Views: 1,326
Posted By 79300sdtd
the freon pressure is further down on the...

the freon pressure is further down on the list...i think his CCU is not making contact (unless it is working fine on the heat settings) if it is working on the heat setting then i'd check the freon...
Showing results 1 to 30 of 500
Page 1 of 17 1 2311 Last »

 
Forum Jump


All times are GMT -4. The time now is 09:33 AM.

Contact Us - Pelican Parts Mercedes-Benz Catalog - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page