|
|
|
|
|
#1
09-13-2008, 02:08 PM
|
||||
|
||||
|
Help...! Front Bearing install: what am I doing wrong??
So I'm right in the middle of this w/my 300D w123 (1982), popped in the new bearing kit and tapped the seal in place. Lots of grease. Then, I can't get the wheel back full on the spindle. So I try and pull it off.... stuck... pull harder, and it leaves bearing and oil seal behind. Did I pop the bearing in bass-ackwards or is it at least facing the right direction?
Hard to tell from the shop manual. See below! -Chuck 
__________________
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ 1982 300D, anthracite grey, 260k miles, Greasecar 1999 E300D, black, 160k miles, Greasecar 2010 Honda Insight Hybrid http://www.chuckwyatt.com http://www.wordimpressive.com Last edited by cewyattjr; 09-13-2008 at 02:26 PM. 
|
| Bookmarks |
|
|
Threaded Mode
