|
|
|
#1
|
|||
|
|||
ATF: Is "too full" always too full?
Hi, everyone,
Sorry to start another transmission fluid level thread, but I haven't been able to find a definitive answer to this, and it's bedeviling me. Most advice here and in the repair manuals seems to say that the transmission fluid should be at or below the maximum mark on the dipstick with the transmission at a “normal operating temperature” of 80°C. Many of the posts here suggest that this can be attained by driving the car for 20 minutes or so on the freeway. But here are my questions:
Most of the time I’ve had the car, the transmission fluid reads about halfway between min and max on the dipstick after easy driving in the city for 10-20 minutes. With this amount of fluid, the transmission shifts reliably, but often with a solid “kick” as it shifts up around 20-25 mph. However, after heavier freeway driving (e.g., 30 minutes at 70-75 mph, on a warm day), the fluid reads about 1/4"-3/8” above the maximum mark. During a long, hot road trip with a bad radiator cap a couple of weeks ago, I removed 8-10 oz of transmission fluid to get it down closer to the max mark, but then as the day got hotter and the hills got steeper (engine temperature up to about 100°C), the level went back up to about 1/4" above full. I left it at this level, but then, once I was home and everything cooled down, the transmission seemed to shift later and less decisively. At that point, the fluid was about 1/8” above the tip of the dipstick when cold (maybe about 3.3 cm below the minimum mark). Even driving for 20 minutes uphill (on a cold day), it didn’t come back up to the maximum, so I added about 6 oz. of ATF, which I think brings me back to about where I started (and brings the performance back to where it started). Now, if I drive 30 minutes on the freeway at 70-75 mph, the fluid is up to about full+1/4”, but otherwise, it is usually between max and min. So, the question is, is the fluid at the right level now, or should I take some out, so it _never_ goes above “max”? Also, if it’s too high now, is it likely that any damage has been done to the transmission by driving hard with 6-10 oz. of extra ATF, and possibly staying at that level for years (I don’t know how full the previous owner usually kept it)? Thanks for your help! Matthias
__________________
1981 300D, 178,000 mi., China Blue |
#2
|
|||
|
|||
On that car with a 722.118 transmission you should start the fluid level 20-25mm BELOW the lowest mark when the fluid is cold! Never should the fluid level go above the highest mark.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
#3
|
|||
|
|||
Your post seems to be asking excellent questions, basically, what constitutes "normal" with respect to operating temperature when you are not able to measure that blasted fluid to see whether it is at 80 degrees C, and then have you filled it to the correct level for whatever temperature it was at when you did the work?
I venture there may be no simple answer, except to suggest that your first advice to run it for about 20 minutes was the best advice. You see, the transmission is cooled by the radiator and once the car runs up to normal operating temperature and stabilizes there, the transmission oil will likewise have attained approximately the same normal temperature as the radiator, roughly 180 degrees F these days and which happens to be, coincidently, very close to 80 degrees C. Therefore, setting the fluid level to the proper mark after warming up as advised should be fine. The transmission is designed to accomodate fluctuations in level due to temperature changes, but over-filling can be bad if the rotating internals foam the oil, the pump will pick up air bubbles rather than oil. Filling to the upper mark when cold will cause the transmission to be too full when hot; filling it to the lower mark when hot equates to under-filling which could lead to a dry pump suction if driving conditions stack up against you. This is also bad news. So, set the oil level as previously advised, look for tell-tale red spots beneath the car and change the oil often to keep the transmission healthy. For what it's worth... 230/8 |
#4
|
|||
|
|||
ATF overfill
I just changed the ATF on my 89 300TE tonight, added 4 qts like the factory manual said, started the engine, ran in through the gears as prescribed, and checked the fluid level. It reads overfull by 10-15mm! What's up? The expected fluid change was 6.7 qts according to the manual. Where did I go wrong?
|
#5
|
|||
|
|||
Did you drain the torque converter??
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
#6
|
|||
|
|||
Nope, just the pan. I got more than a gallon out when I drained it.
|
#7
|
|||
|
|||
Since you left 1/2 of the fluid capacity in the converter you needed only 1/2 of the total quanity.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
#8
|
|||
|
|||
Transmission fluid expands when hot, quite a bit actually, so it will read high when the tranny is quite warm, as in climbing hills, etc.
Check it after driving enough to get it up to operating temp, and make sure it stays below the top mark in those conditions, and you will be fine. Towing a heavy trailer in the mountains will require an additional cooler to keep it from "overfilling" due to heat and associated tranny failure. I've seen this several times, it's not fun. Peter
__________________
1972 220D ?? miles 1988 300E 200,012 1987 300D Turbo killed 9/25/07, 275,000 miles 1985 Volvo 740 GLE Turobodiesel 218,000 1972 280 SE 4.5 165, 000 - It runs! |
#9
|
|||
|
|||
psfred wrote:
Quote:
At this point, I'm assuming that the right thing to do is to get the fluid level to "full" when I've been driving around town or on the freeway for 20 minutes or so, with the engine up to about 80°C (which I think will also correspond to about 30 mm below the minimum with the transmission at 20-30°C). Then, if it goes a little higher when I'm out climbing over the mountains, I assume that's OK too. This is contrary to what M.B. Doc said on 8/30, but seems to match what 230/8 suggested, and what I've been able to glean from the service manual. For what it's worth, even with the range of temperatures and levels the transmission fluid has been at (up to about 9 mm above max at the hottest/fullest, or down to about 35mm below the minimum at coolest/least filled), I've never noticed any bubbles or burnt smell on the dipstick. The worst I've had is hesitant shifting (and maybe a hint of flaring) at low fluid levels.
__________________
1981 300D, 178,000 mi., China Blue |
#10
|
|||
|
|||
Check at normal operating temperature after driving long enough to get the tranny fully up to temp (about 20 min).
There is space in the transmission for the fluid to expand in normal service. If you decide to tow a boat or large trailer, etc, get an accessory transmission cooler, else it will overheat. Peter
__________________
1972 220D ?? miles 1988 300E 200,012 1987 300D Turbo killed 9/25/07, 275,000 miles 1985 Volvo 740 GLE Turobodiesel 218,000 1972 280 SE 4.5 165, 000 - It runs! |
#11
|
|||
|
|||
89 300TE trans slipping
I should have posted this reply here, instead of as a new thread:
I have a 89 300TE with 155k miles, trans replaced at 100k with rebuilt (not by dealer). I bought the vehicle 18 months ago, and have had no troubles (with the tranny anyway) until recently. Last week I started noticing a slight delay as the car shifted from 3-4. Now it's more noticeable, although not always consistent, and I'm begining to feel it in 2-3. I changed the fluid two days ago, everything appeared normal- no discoloration or material in the pan. My next step is to take it to a transmission expert, since I'm an hour away from the nearest MB dealer. Any thoughts or recommendations would be much appreciated. |
Bookmarks |
|
|