Having trouble getting to the rear bearings to replace. Can someone please explains the steps? I have attached a picture of where I am currently stuck.

Thank you.

Attached Thumbnails

 

i dont have one of them cars but is the bearing a single solid unit which need a compressor to fit or inner and outer tappered bearings??

Single unit...bought the the bearing already assembled from Autozone (already connected to hub).

simple job then

on your picy you will note larger holes on the hub this is to allow a sochet to be inserted for hub removal and must be turned for each bolt, first remove the main centre bolt

What's your suggestion? Did you see the pic I posted...do I pry off that part that appears to be connect some how to the axle?

i seen the pic and it needs to be hammered from the rear and could be very tight which is normal but it will give unless you have an expensive puller