Location of Starter/Ignition wires
I'm trying to install a remote starter on my 1991 300E, and have a quick question.
I need 4 wires: the 12volt constant, starter, ignition, and accessory. My manual says to access these wires behind the instrument cluster. The only problem is after pulling the cluster, the wires have 0 slack. I have access to maybe an inch or two of those wires mentioned above, and yanking on them yeilds nothing. Is there another location where I can tap into those wires? Anywhere other than behind the cluster is fine, even under the hood would be easier. Thanks! -E |
My guess is that you did not disconnect the speedometer cable. Do search on removal of cluster how to get additional slack on the cable.
|
Is behind the cluster the only place to access all these wires?
|
All times are GMT -4. The time now is 06:27 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website