|
|
|
#1
|
|||
|
|||
small transmission problem
My '83 300d bangs into reverse and bangs into 2nd gear. All other gears work OK. There is no slippage I can detect, although the engine races a little as it tries to shift from 1st to 2nd, then bangs into second. Is there any adjustment to correct this? Or should I just take it to a tranny shop?
|
#2
|
||||
|
||||
Do a search on here concerning vacuum. Sounds like yours is not getting the correct vacuum signal. Steve Brotherton has an article somewhere around here that discusses it.
__________________
Jim |
#3
|
|||
|
|||
HARSH engagement in reverse isn't adjustable at all! Either you have the idle speed too high OR there is an internal trans problem! Has the fluid been changed frequently?
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
#4
|
|||
|
|||
might be a combination of a worn front flex disc and a vacuum problem.
Stefan. |
#5
|
|||
|
|||
trans problem
Quote:
|
#6
|
|||
|
|||
First inspect front flex disk and replace if necessary.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transmission problem and question | Hector111 | Diesel Discussion | 8 | 08-21-2005 08:42 AM |
Transmission problem 500E | Henrik | Tech Help | 0 | 08-25-2004 11:06 AM |
I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Diesel Discussion | 8 | 12-09-2003 12:04 AM |
I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Tech Help | 6 | 12-08-2003 10:19 AM |
Transmission Problem | Ernesto | Diesel Discussion | 1 | 08-27-2002 10:36 PM |