Propellor Shaft Sleeve Nut Size? - PeachParts Mercedes-Benz Forum

Parts Catalog

Accessories Catalog

How To Articles

Tech Forums

Call Pelican Parts at 888-280-7799

		PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help
Propellor Shaft Sleeve Nut Size?

ShopForum Gallery

Prev

Previous Post

Next Post

Next

#1

Old

07-10-2005, 02:35 PM

Phalcon51

Phalcon51 is offline

Registered User

Join Date: Jun 2002

Location: Monrovia, CA

Posts: 496

Propellor Shaft Sleeve Nut Size?

Does anyone know the driveshaft sleeve nut size on an 86 300E? And is it just one nut or is there a locking nut as well? If so, same size or different size? Is the nut in a gap wide enough to use a crescent wrench if I can't find the proper size open-end? The car is at a remote location and I need to know before I make the trip. Also, can the support bearing be removed and replaced without a special puller/installer?

Thanks,

Gary

Reply With Quote

Bookmarks

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sun Roof -what is thread size of nut ?	tino	Tech Help	1	05-20-2005 09:02 AM
Size of nut on rear of trans. output shaft?	Jetmugg	Diesel Discussion	3	05-08-2005 01:33 AM
Bosche KE FI Manual	BAd124	Tech Help	27	11-13-2004 10:10 AM
what size nut do I need?	pkmorgan17	Diesel Discussion	1	06-27-2002 01:23 AM
Remove Nut or Nut, bolt and Sleeve on P/S Fluid Reservoir?	Steve Gutman	Tech Help	1	05-16-2002 02:05 PM

All times are GMT -4. The time now is 02:16 AM.