![]() |
|
|
|
|
#1
|
|||
|
|||
1995 C280 will not start after plug change
!995 C280, changed the plugs and now it will not start. Smell fuel after crank so assume that isn't the issue. Replaced the OVP relay which did not help. There is no spark at the plugs....
Any idea what might be going on here? |
#2
|
|||
|
|||
Is the wiring harness that you molested to get at the plugs original? If so that would be the likely suspect.
|
#3
|
|||
|
|||
Not sure on the harness. I am guessing it is. Is there a certain failure prone spot on these that I can patch up to verify the harness is the issue? What seems to be the failure in the harness?
Thanks |
#4
|
|||
|
|||
Quote:
|
#5
|
|||
|
|||
Well I suppose that will be my area of focus then. Am i to assume the wires within the harness will be able to be identified as being the issue as I get into the wireloom? I looked at the ourside loom covering which looked good but I guess it would be inside where the problem lies...
Thanks |
#6
|
|||
|
|||
If I were you I would get the part number off the wiring harness, take it to the dealer and ask them whether it's original or a replacement - because if it's original it's shot, and if it's a replacement it should be fine. No need to do this if you can see crumbling insulation - just replace it. The part number is near the source plug by the battery. You may have to unplug it to find it. I tried repair but it lasted for only a few weeks. It fails first nearest to heat sources but once it's failing there it's suspect just about everywhere - and it's gotta go.
|
#7
|
|||
|
|||
Quote:
|
#8
|
|||
|
|||
Quote:
I don't think I would ever buy another mercedes after seeing this mess. |
#9
|
||||
|
||||
check out this thread:
MB Wiring Harness Failure also post your complaint/issue to the NHTSA complaint thread listed AND call MBUSA and ask to speak to John Hart, a supervisor at MBUSA, who claims to have NEVER heard of this problem: 1-800-FOR-MERCEDES (1-800-367-6372) perhaps someday mercedes will address this issue (ha! i laugh at myself even for thinking this) BTW: It only affected the 93-95 MBs as they changed the wiring in the '96 MY |
#10
|
|||
|
|||
There was a post not long ago about trying to start a class action or something. The thing that irks me about is that the price just keeps going up - used to be three hundred something a few years ago and is now more than twice that. You'd think with such a screw-up they could at least be a little reasonable on the prices increases. They seem to have no shame.
|
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
C280 failing to start | Veloce300DT | Tech Help | 2 | 05-31-2004 11:20 PM |
C280 Spark Plug Connectors | ericp | Tech Help | 0 | 05-27-2004 03:49 PM |
96 C280 stalls on hot start | orvals | Tech Help | 0 | 04-28-2004 02:46 AM |
HELP! My 95' C280 (W202) won't start? | Briantam | Tech Help | 2 | 06-20-2003 01:03 PM |
no start after valve job on 95 c280 | toplesssl | Tech Help | 2 | 09-20-2002 06:53 PM |