|
|
|
|
|
|
|
|
#1
|
|||
|
|||
|
A/C hot and cold at the same time
Hi,
The car is a W210 E230. The A/C blows cold on the right side and right center vent and warm air on the left and left center vent. People say it must be the DuoValve part.?? I want to be perfectly sure first before I purchase this part since it is quite expensive. To be sure, I pulled out the error codes on the A/C switches and was expecting a B1417 code (duovalve left) but this code did not come up. What came up are B1416 (coolant circulation pump) and a B1226 (in car temp sensor) Is this related to the aircon problem?? Thanks for any help.. |
|
#2
|
||||
|
||||
|
That's got duovalve written all over it. I had the exact same thing happen on my C280. Your coolant pump code relates to the small pump on the right fenderwell that circulates coolant when you press the 'rest' button. It also assists the heater circuit at idle, othewise the duovalve opens to compensate for the low flow at idle, and when you take off, you get a blast of hot air until it can compensate. The sensor problem is one I'd have fixed at the same time.
__________________
'96 C280 (gone) '97 C36 '05 C230k |
|
#3
|
||||
|
||||
|
Quote:
Of course, where you live you'd never notice this.
__________________
'96 C280 (gone) '97 C36 '05 C230k |
|
#4
|
|||
|
|||
|
Is the left side air actually heated, or merely outside temperature? The symptoms described are also typical of a 210 which is low on refrigerant and requires a recharge. Suggest checking this before replacing the duovalve as it is common and a much less expensive repair.
- JimY |
|
#5
|
||||
|
||||
|
No. Low on refrigerant will show a difference between center and outside vent temperature sometimes. A side to side difference split at the middle of the center vent is duovalve. Guaranteed.
Later or upper end models had the dual zone climate control, and on the earlier models, the system was the same, but the controls were not implemented. The duovalve can accomodate dual zone climate control, as the heater core has 2 separate circuits, each controlled by half the duovalve. On cars without dual zone controls, both solenoids of the duovalve are controlled by the same signal. When one solenoid fails, the difference in heating is split dead center in the middle vent. This failure can also be distinguished from a flap failure by the fact that the side vent is involved as well.
__________________
'96 C280 (gone) '97 C36 '05 C230k |
|
#6
|
|||
|
|||
|
Follow up question
Wow!! thanks for those great inputs!! I'll ask one more advise please?
I went to a corner benz mechanic and he suggested plugging the hose from the duovalve going to the engine so that the hot coolant would not enter. I do not need the heater anyway so plugging it with some rubber or whatever would be fine?? I tried disconnecting the duovalves but the aircon now blows weak air. So i just returned the connection since this was not right. Hmmmm. Would plugging the hose be OK??? |
![]() |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A/C system blowing hot and cold in W210 | Rahulio1989300E | Tech Help | 3 | 06-24-2005 03:05 PM |
| 93 300e A/C problem, hot air side vents, cold air center vents | mononucleusque | Tech Help | 2 | 04-21-2005 02:23 PM |
| A/C cold, then hot, than cold??? | Jackd | Tech Help | 6 | 10-07-2002 07:39 PM |
| 78 300d A/C Blowing Hot and Cold at same time | robmai | Tech Help | 0 | 09-22-2002 01:38 AM |
| A/C Blowing Hot and Cold Simultaneously!! | EstebanSPI | Tech Help | 3 | 07-23-2002 08:50 AM |