|
|
|
|
|
#1
02-04-2001, 08:24 PM
|
|||
|
|||
|
Thanks Steve for the reply.My DOHC V8 drivers side front cylinder is the farthest one forward. I'll hold your answer up to a mirror. I just did a head gasket job and only had five parts left over!Not bad all things considered. I'm not really concerned about the three bolts(how important could they have been?-better hp/lb ratio).However,I vaguely remember removing three circlips(e-clips) from the bowden cable and I still have two left over.I wonder where they go?
|
|
#2
02-05-2001, 09:49 PM
|
|||
|
|||
|
The only E clips go at the pivot points on the bell cranks of the throttle linkage.
__________________
Benzmac: Donnie Drummonds ASE CERTIFIED MASTER AUTO TECHNICIAN MERCEDES SPECIALIST 11 YRS
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear self levelling adjustment resolved!!!!! | alexkor | Tech Help | 4 | 10-17-2004 08:06 PM |
| '95 E420 Throttle Actuator | kogermeister | Tech Help | 1 | 07-12-2004 08:25 PM |
| '97 E420 - ASR & Check Engine Electronics Warning; Throttle Actuator Failure? | jgl1 | Tech Help | 10 | 01-08-2004 10:59 AM |
| How to Clean or Maintain Throttle Valve Actuator on 1994 E420 | screedchan | Tech Help | 9 | 10-24-2001 11:12 PM |
| E420 throttle lever | markE420 | Tech Help | 1 | 02-07-2001 08:29 PM |
Linear Mode
