Need second opinion, Tech at ind. shop believes that
4 blinks is Airflow Sensor. He says a very pricy part. ($400) Wouldn't know for sure until part is installed.
Also said 1 blink is end of codes. Due to my budget I may
have to get at auto recycler. I was wondering if anyone
has replaced these things and what is involved. Do you
need any special tools????? etc.

Also, EHA is leaking fuel. Will o-rings fix this????
I an wondering if these parts fail very often. (EHA)

Any ideas?????

Unfortunately the EHA is usually what leaks. The o-rings usually aren't the problem (unless you leave them out).

I looked at the code table and 4 is for the airflow potentiometer. The device isn't sold separate from the airmeter housing. It should be tested to verify the problem. The device has a three wire connector that should have 5v, ground and the control signal. The control signal should be .5-.9v at idle and go up toward five volts.

__________________
Steve Brotherton
Continental Imports
Gainesville FL
Bosch Master, ASE Master, L1
33 years MB technician

Thanks for replying Steve. I will check voltage.

Gary