|
|
|
|
|
#1
01-02-2006, 11:17 PM
|
|||
|
|||
|
M112/E320 Need torque spec for oil pressure test cover
This is for my '98 E320 with a M112 engine. I've got a small leak from the oil pressure test cover (located just under the oil filter housing). I've got a new gasket to seal things up, but what is the torque spec for the two bolts that hold the cover?
If it helps, the fasteners are E20 torx bolts. Thanks in advance.
__________________
1998 E320 120K mi 1991 Miata 80K mi 2001 Ranger 109K mi 
|
|
#2
01-03-2006, 08:42 PM
|
||||
|
||||
|
Hey,
14nm for 2 bolts. 20mn for center plug bolt. Regards, Dr.D
__________________
Dr.Diesel - Shop Foreman Master Guild Mercedes-Benz Technician. Think the dealer is expensive? Do you know how much it costs to train a dealer tech? Or buy the required MB special tools to have on hand? 
|
 |
| Bookmarks |
|
|
Linear Mode
