|
|
|
|
|
#1
12-31-2005, 11:55 AM
|
|||
|
|||
Tranny Problems
Today I just put my tranny back together on my 1985 500sel, Now i believe it could be a bad b2 piston for sure. Now to my question where is the b2 piston located on the tranny and do I have to pull out the whole tranny or can i operate while it is still on the car. I have pull the valve housing out and the valves are working fine, the car still will not move until the rpms are at 2800
Thanks hollow 
|
|
#3
12-31-2005, 01:24 PM
|
||||
|
||||
|
Peep this
__________________
Fourings  84 Audi Coupe GT with Turbo engine, EFI (buh-bye CIS), Jamex seats, Koni's/H&R's, e-code lights. 210k and counting. 1992 Anthracite 400E, 161k, "Grey Ghost". 1986 VW Quantum Syncro, 192k, gone to the crusher in the sky. 1989 300TE 172k. (Was mine, now also Mom's car) 72 280SE 4.5 (Mom's car)
|
|
#4
01-05-2006, 02:11 PM
|
|||
|
|||
|
Reverse works fine, I have the good idea it is the b2 piston. Now the link on this tread is very helpful but when looking for the b2 piston, but is it on the the driver side or passenger side??????
Last edited by hollow6669; 01-06-2006 at 06:32 PM.
|
|
#5
01-07-2006, 08:44 AM
|
|||
|
|||
|
I have got what i think is the b2 piston out and it doesn't seem broken, it came out in one piece, could something be wrong inside the piston?????
|
 |
| Bookmarks |
|
|
Linear Mode
