I have to remove a crank sprocket (other car) that's stuck solid, in order to replace the oil seal that's behind it. My plan is to drill some 5mm holes in the sprocket, so that it gives way (don't like grinding: too brutal )
This sprocket looks like it's made of hardened steel, so the regular HSS bits won't work I guess.
I've heard of these cobalt drill bits, can someone recommend these, or even better ones for this job ??

Thanks,
V.

__________________
2011 Prius

Can you take a snap shot of the crank gear and paste the image to a response? If we can see what you are up against we might be able to direct you more effectively with some real world experiences.

IMHO-cobalt bits are one of the best bits to use; however you do need to keep in mind that when a drill bit spins too fast all it will do is burn the cutting edge. When drilling you want to see curly cues of steel being removed, if you do not see them than you are spinning the bit too fast..........

IMHO-cobalt bits are one of the best bits to use; however you do need to keep in mind that when a drill bit spins too fast all it will do is burn the cutting edge. When drilling you want to see curly cues of steel being removed, if you do not see them than you are spinning the bit too fast..........

He is right on about the danger of insufficient pressure on the bit resulting in overheating and ruining the bit. You're best off with a half-inch drill and positioning yourself to exert enough force so that you see thin strips of the sprocket as you drill. It is the thin strips which removes heat from the drill and sprocket as you drill.

Thanks Fella's,
Here's a pic of the wheel with the little woodruff key in the centre positioning the sprocket on the crankshaft:


It looks like as if the circle in de middle is composed of different metal than both the inner circle and the cogs on the outside. The sprocket measures 2.5 inches diameter, and is less than 1 inch deep. The diameter of the crank is a little over 1 inch. My plan is to drill two holes of 5mm above the woodruff key, to create a wedge running from the centre to the cogs, to release the grip of the sprocket on the crank.

At the back of the sprocket there's one (now damaged ) of the two conical disks that guide the belt. Behind the disk is the oilpump, and the black object beneath is the oil sump

__________________
2011 Prius

Since you are planning to replace the gear, you might consider an air chisel straight down into the root of the gear teeth like you were trying to split the gear. Spray with penetrating oil first then try to spit the gear. You shouldent need to split it all the way. Once you get a wedge about 3 mm down with the chisel the gear will probably slid right off.

John Roncallo

leery of trying the chisel behind the sprocket. the block appears to be aluminum. you could damage it i think. the sprocket is too tight to get the fingers of a puller in there?

the center of the sprocket seems to be a softer material to alleviate vibrations. so it sounds like you are will ing to destroy the sprocket. if you do that maybe there will be room at the back of the center piece of steel at the base of the sprocket. can you find a cross section of the sprocket?? to see if this might be true? i think it prob is not true. but might be worth checking into. what does the repair manual say?

tom w

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.