|
|
|
|
|
#1
08-20-2011, 10:34 AM
|
|||
|
|||
|
Monovalve Question
Car is a 1984 300 SD.
I'm replacing the entire monovalve housing. When I remove the tubes I suppose I will loose some coolant. How much? Also, by replacing the entire unit am I going to introduce air into the system and if so how can I prevent it from happening? Thanks.
__________________
1984 300 SD 384,000 Miles 
|
|
#2
08-20-2011, 02:31 PM
|
|||
|
|||
|
Not much coolant loss, it sits high up in the cooling system. Don't worry about air in the system, it will readily bleed itself in a short test drive.
__________________
 90 300TE 4-M Turbo 103, T3/T04E 50 trim T04B cover .60 AR Stage 3 turbine .63 AR A2W I/C, 40 LB/HR MS2E, 60-2 Direct Coil Control 3" Exh, AEM W/B O2 Underdrive Alt. and P/S Pulleys, Vented Rear Discs, .034 Booster. 3.07 diffs 1st Gear Start 90 300CE 104.980 Milled & ported head, 10.3:1 compression 197° intake cam w/20° advancer Tuned CIS ECU 4° ignition advance PCS TCM2000, built 722.6 600W networked suction fan Sportline sway bars V8 rear subframe, Quaife ATB 3.06 diff
|
 |
| Bookmarks |
|
|
Linear Mode
