I was called on a 1966 250-SE, it is a no start. This Vehicle is Fuel injected. Can anyone tell me fuel pressure, and also Injector pluse requirement, also maybe point set/gap. I have no info on this car. Thank you for any help.

[Edited by Carphd! on 04-12-2001 at 07:27 PM]

I assume you mean a 1966 250SE... [If you had another car in mind, let me know]

Quoting the 1966 TDM...

- With the engine not running and the battery reading atleast 11v, the pressure down stream of the filter should be 0.8 to 1.1 kg/cm-squared (which is 14.88 lbs/square-inch).

- At the overflow valve of the injection pump, the pressure should be AT LEAST 1.3 kg/cm-squared.

- Fuel should be delivered at that same point at a rate of AT LEAST 3 liters/minute.

- The point gap should be 0.3-0.4mm, resulting in a dwell of 37-41 degrees. For new points aim for the 41 figure. Also test dwell at idle and 4000rpm. If there is a deviation of greater than 3 degrees, rebuild the distributor.

There is a great writeup of mechanical fuel injected systems http://www.pelicanparts.com/techarticles/911_MFI/TipMFI.htm

-CTH