C220D P1227 problem
Being my first post, I'd like to say HI to every respected member of this forum.
I have a C220D '96 car, and after the diagnostics I get the following error: P1227 Distributor Shaft Position Sensor Y 23/2 | 2 or in german P1227 Positionsgeber Verteilerwelle Y 23/2 | 2 I am trying to get the description with this error so I can find the part that is damaged and possible solutions. Any help in this direction is highly appreciated. Thanks in Advance! |
At least a full description of the problem?
|
This is usually easier if YOU first give us a description of the problem.......
Are you experiencing a no start condition? FYI -Your engine was never imported to the US. Is it a 202.121 or a 202.193? Possible issue MAY be the crank position sensor although this is not a common failure on a diesel in my expirience. |
I agree, more information is required, my German is not good at best and my technical German is worse still, but I think it is the camshaft sensor and not crankshaft sensor.
Please furnish chassis number and engine number. Descibe also more about the fault you are experiencing. |
Hy.I have the same problem, and i still didn't fix it.The EPC light apears, and the engine stop's working properly.The diagnostic program, shows the same error "P1227-Distribution shaft position sensor".The car is MB W210 E220 D 1996, engine 604.912 .And the engine starts normaly, the car is running, but the acceleration it's not working properly.The only gear that work's are the 1, 2, and 3 .Hope to solve it soon .Thanks guys . (please excuse my english, it's a little bit rusty) thank's again
|
All times are GMT -4. The time now is 06:05 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website