|
|
|
|
|
#1
06-25-2001, 10:49 PM
|
|||
|
|||
|
So I get into my 1969 2890 SEL, start it up and put the column mounted shifter into DRIVE and nothing happens. I open the hood and I can see that the lever that actuates the shifter on the side of the tranny has dropped off. It's the actuator rod which snaps on at the front but seems to be held on differently at the rear where it turns the shifter. How is this rod held onto this little ball joint anyway? Any thoughts out there? Thanks in advance.
Thom
__________________
1987 300E 1967 Jaguar E-type Series I, 2+2 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I've dropped from #7 to #11..... | suginami | Off-Topic Discussion | 10 | 02-17-2004 12:35 PM |
| I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Diesel Discussion | 8 | 12-09-2003 12:04 AM |
| I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Tech Help | 6 | 12-08-2003 10:19 AM |
| Help!! Dropped exacto knife down defroster vent!! | cardsnapper | Tech Help | 5 | 09-23-2003 05:01 PM |
| springs that dropped 2" | daulia71 | Mercedes-Benz Wheels & Tires | 4 | 06-12-2002 04:56 PM |
Threaded Mode
